Summary

This doc covers the "Jake Valve", a replacement for the Hot Water Needle Valve discovered/designed by Jake_G from Home-Barista.

BOM

Remove top cover
Remove hot water knob by popping off cover and unscrewing screw in center of knob
Remove two screws holding valve to frame
Remove two screw holding valve mount inside
Disconnect two tubes from valve and remove old valve
Screw female push connect into new valve
Slide 3D printed shaft onto new valve shaft
Slide new valve into 3D printed housing, 3D printed shaft first
Screw male push connect into new valve through hole in housing
Slide internal mounting bracket onto new assembly
Reattach tubes
Reassemble

Cross Section